1. Home
  2. Knowledge Base
  3. Connect+ Panel Firmware Release Notes
  4. Connect+ Panel Firmware Release Notes v1.1.14.0

Connect+ Panel Firmware Release Notes v1.1.14.0

Major features for this release include modifications to keep silent panic “silent” on the premise.  This is important for our SMB customer safety in a panic situation. Significant effort was included to support GSM communications modules for alarm reporting and two-way voice functions.  Additionally, the panel is now reporting status on a 5 second interval during the panel entry and alarm delay periods.

 

-Added support for Outdoor DWS.

-Detect and reset DeviceLink module if no message from any enrolled Touchpad is received within 15 minutes.  Previous detection mechanism required 4 hours.

-Improved battery management by shutting down DeviceLink module if AC power is lost for more than 3 hours.

-Improved handling of OTA updates when panel is armed.

-Changed the event report event code for repeater AC fail from 1370 (generic zone trouble) to 1342.

-Enable keystroke tamper function (defaults off). If 40 keystrokes are received without a valid PIN, keystroke tamper is asserted and all keypads enter a 5 minute lockout.  If armed, a panel tamper alarm is started.

-Added suppression of Touchpad display for zones with alarm type of SILENT_PANIC (always show CLOSED).

-Panel status is reported to server every 5 seconds during entry and alarm report delays.

-Allow more than 3 panel updates per day when initiated by a Check for Updates command.  This will ensure that all updates are delivered in the same check in interval when requested by a user.

-Added silent protest panel option.

-Add zone configuration option for Normally Open or Normally Closed.

-Add support for 2 way voice using VOIP over GSM.

-Add option to allow 2 way voice during fire alarms.

-Z-Wave improvements, updates and bug fixes for certification.

-Various bug fixes.

Was this article helpful?

Related Articles