1. Home
  2. Knowledge Base
  3. General
  4. Board Button Configuration

1 Tap – Device will go into WPS mode and should search for nearest WPS activated Wi-Fi router in the area.

2 Taps – Device will indicate Wi-Fi signal strength [Device must be paired to a Wi-Fi]

3 Taps – CDMA Module Service Provisioning (OTAP)

4 Taps – Device will force a firmware upgrade [Device must be paired to the a Wi-F- router]

5 Taps – Device will factory reset and lose connection to any Wi-Fi it was previously attached to.

  • Should any pairing issues occur, press the SW1 button 5 times to factory reset and start the pairing process over.

Was this article helpful?

Related Articles