Activity (LED) Lights
LED 1 –Â is used for DHCP & Network connection diagnostics: Solid: Indicates a connection has been made to Alula. (The...
Board Button Configuration
1 Tap – Device will go into WPS mode and should search for nearest WPS activated Wi-Fi router in the area. 2...
To a BAT-CDMA/WIFI/LTE
Terminal 1(TIP) should be wired to Tip on the alarm panel (used for communication) Terminal 2(RING) should be wired to...
To A BAT-CDMA-L
Terminal 1(RING) should be wired to Ring on the panel (used for communication) Terminal 2(TIP) should be wired to Tip...
To a CAT-CDMA (red board)
Terminal 1(RING) should be wired to Ring on the panel (used for communication) Terminal 2(TIP) should be wired to Tip...
To a CAT-CDMA-L (black board)
Terminal 1(RING) should be wired to Ring on the panel (used for communication) Terminal 2(TIP) should be wired to Tip...
To A BAT-CDMA (black board)
Terminal 1(TIP) should be wired to Tip on the panel (used for communication) Terminal 2(RING) should be wired to Ring...
To A BAT-CDMA (green board)
Terminal 1(TIP) should be wired to Tip on the panel (used for communication) Terminal 2(RING) should be wired to Ring...
Antennas Part Descriptions
Our CDMA devices are compatible with any high-gain antenna that has: Â a SMA connection Frequency range of 800, 1900 MHz...
Connecting To A Wireless Network (AP Configuration)
Tap the SW1 button 5 times (top left button) On your smartphone or laptop, turn your Wifi connection off then...
Connecting To A Wireless Network (WPS)
Tap SW1 the button 5 times (top left button) Follow the router’s directions to turn on WPS. Now tap the...
BAT-CDMA-WIFI Board Button Configuration
1 Tap – Device will go into WPS mode and should search for nearest WPS activated Wi-Fi router in the...
Activity(LED) Lights (WiFi Devices) Board Button Configuration
LED 1 – is used for DHCP & Network connection diagnostics: Solid: Indicates a connection has been made to ipDatatel....
BAT-WIFI Board Button Configuration
1 Tap – Device will go into WPS mode and should search for nearest WPS activated Wi-Fi router in the...
Activity (LED) Lights (CDMA/LTE Devices) – Board Button Configuration
LED 9 –currently not being used LED 1 – When solid the device is ‘Online’ When blinking the device if...
How do I get my IGM to support partition 2 on my panel?
The IGM can support Event Reporting and Zone Reporting from multiple partitions. This can be configured at the bottom of...
My IGM is not joining the panel.
Ensure the manufacturer selector switch is on the proper setting. Â UTC=Concord; HW=Vista; CDX=Interlogix NX Panel; DSC=DSC Power Series. If selected...
The IGM is not joining my Vista panel properly.
Disable Remote Interactive Services (RIS) on the Vista: Â *91 on older systems was referred to as the “Call Waiting” feature....
