-
Home
-
Knowledge Base
-
Legacy Products
-
To A BAT-CDMA (green board)
- Terminal 1(TIP) should be wired to Tip on the panel (used for communication)
- Terminal 2(RING) should be wired to Ring on the panel (used for communication)
- Terminal 3(6-24v-POS AUX) should be wired to Pos aux on the panel
- Terminal 4(NEG AUX) should be wired to Neg aux on the panel
- Terminal 5(Y IN) should be wired to the programmable output on the panel (used for interactive service)
- Terminal 13(OC1) should be wired to any open zone on the panel (used for interactive service)
- a zone resistor (used to indicate change of state) should be placed parallel on Terminal 3 to Terminal 5 on the BAT CDMA
Was this article helpful?
