You searched for - Page 3 of 17

My IGM is not joining the panel.

Ensure the manufacturer selector switch is on the proper setting. UTC=Concord; HW=Vista; CDX=Interlogix NX Panel; DSC=DSC Power Series. If selected properly check wiring diagram in the IGM manual.

August 21, 2015

The IGM is not joining my Vista panel properly.

Disable Remote Interactive Services (RIS) on the Vista: *91 on older systems was referred to as the “Call Waiting” feature. It now has been expanded to include “Remote

August 21, 2015

Adding & Deleting Devices

Adding & Deleting Devices 1. Prior to adding a new device, if that device has ever been previously used with any other system, or if you’re not sure,

September 3, 2015

General Z-Wave Tricks & Tips

General Z-Wave Notes Z-Wave can experience limited range. 50 feet max with additional variables for rf interference. If customer wants to place a device farther than this, or

September 3, 2015

Connect+ CP-01 Compliance Features

Connect+ added CP-01 compliance features in firmware version 0.5.11.00. The following article covers the functional changes for compliance. CP-01 compliance for false alarm reduction. Functional changes are: Silent arming

September 30, 2017

Activity (LED) Lights

LED 1 – is used for DHCP & Network connection diagnostics: Solid: Indicates a connection has been made to Alula. (The device is Online) 3-Flashes: Indicates the device is

February 2, 2018

Board Button Configuration

1 Tap – Device will go into WPS mode and should search for nearest WPS activated Wi-Fi router in the area. 2 Taps – Device will indicate Wi-Fi signal strength [Device must

February 2, 2018

To a BAT-CDMA/WIFI/LTE

Terminal 1(TIP) should be wired to Tip on the alarm panel (used for communication) Terminal 2(RING) should be wired to Ring on the alarm panel (used for communication)

February 4, 2018

To A BAT-CDMA-L

Terminal 1(RING) should be wired to Ring on the panel (used for communication) Terminal 2(TIP) should be wired to Tip on the panel (used for communication) Terminal 3(NEG

February 4, 2018

To a CAT-CDMA (red board)

Terminal 1(RING) should be wired to Ring on the panel (used for communication) Terminal 2(TIP) should be wired to Tip on the panel (used for communication) Terminal 3(NEG

February 4, 2018

Search Results for: – Page 3

My IGM is not joining the panel.

The IGM is not joining my Vista panel properly.

Adding & Deleting Devices

General Z-Wave Tricks & Tips

Connect+ CP-01 Compliance Features

Activity (LED) Lights

Board Button Configuration

To a BAT-CDMA/WIFI/LTE

To A BAT-CDMA-L

To a CAT-CDMA (red board)

Resources

Learn More

Download Our App

1-888-88-ALULA

St Paul Office